Electric Hydraulic Power Crimping Tool EZ-300 for Terminals Range Up To 300mm2, Head Rotates 350°
|Crimping Force ||60KN |
|Stroke ||17mm |
|Crimps per charge ||320 times (Cu 150mm2 ) |
|Crimping cycle ||3-6s (depends on the size of cable) |
|Battery voltage ||18V |
|Battery capacity ||3.0Ah |
|Charging time ||2hours |
|Package ||Steel case |
|Crimping Dies. ||16, 25, 35, 50, 70, 95, 120, 150, 185, 240,300mm2 |
|Battery ||2pcs |
|Charger ||1pcs |
|Sealing ring of cylinder ||1set |
|Sealing ring safety valve ||1set |
Hydraulic Power Crimping Tool EZ-300
The hydraulic unit incorporates an automatic retraction which returns the piston into its starting position when the maximum operating pressure is reached.
A manual retraction allows the user to return the piston into the starting position in case of an incorrect crimp. The unit is equipped with a special brake when stops the forward motion of the piston & die when the trigger is released.
The unit is equipped with a double piston pump which is characterized by a rapid approach of the dies forwards the connector and a slow crimping motion.
The crimping head can be smoothly turned by 350° around the longitudinal axis in order to gain better access to tight corners and other difficult working areas.
Li-ion batteries do neither have a memory effect nor self discharge. Even after long periods of no operation, the tool is always ready to operate. In addition we see a lower power weight ratio with 50% more capacity and shorter charging cycles compare to NiMH batteries.
A Temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduced to the normal.