Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs
Technical Data Sheet
Battery Powered Wire Crimping Tool with Micro Computer Control System,for pressing Copper and Aluminum Terminals EZ-400U
crimping Force | 120KN |
Stroke | 20mm |
Crimps per charge | 150 times (Cu 150mm2 ) |
crimping cycle | 4-12s (depends on the size of cable) |
Battery voltage | 18V |
Battery capacity | 3.0 Ah |
Charging time | 2hours |
Package | Plastic case |
Accessories | |
crimping Dies. | 16, 25, 35, 50, 70, 95, 120, 150, 185, 240, 300, 400mm2 |
Battery | 2pcs |
Charger | 1pcs |
Sealing ring of cylinder | 1set |
Sealing ring safety valve | 1set |
Battery Powered Wire Crimping Tools with Micro Computer Control System
Micro computer control system-automatically detect the pressure when it is crimping, with double safety protect.
The tool equipped with a double piston pump which characterized by a fast approach towards the connecting material and transfer to high pressure automatically by slow crimping.
If a deviation from the set operation pressure or low battery charges is identified, an acoustic signal sounds and a red display flashes.
One key control-press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully means piston return to the original position.
A Temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduced to the normal.