Hydraulic Compression Tools with H Type, Micro Computer Control System, for Crimping Copper And Aluminum Terminals BZ-400U
Technical Data Sheet
Hydraulic Compression Tools with H Type, Micro Computer Control System, for Crimping Copper And Aluminum Terminals BZ-400U
| crimping Force | 120KN |
| Stroke | 20mm |
| Crimps per charge | 150 times (Cu 150mm2 ) |
| crimping cycle | 4-12s (depends on the size of cable) |
| Battery voltage | 18V |
| Battery capacity | 3.0 Ah |
| Charging time | 2hours |
| Package | Steel case |
| Accessories | |
| crimping Dies. | 16, 25, 35, 50, 70, 95, 120, 150, 185, 240, 300, 400mm2 |
| Battery | 2pcs |
| Charger | 1pcs |
| Sealing ring of cylinder | 1set |
| Sealing ring safety valve | 1set |
BZ-400U Battery hydraulic compression tools with Micro Computer Control System,for crimping Copper and Aluminum Terminals
Battery powered crimping tool 16,25,35,50,70,95,120,150,185,240,300,400mm2
Micro computer control system-automatically detect the pressure when it is crimping, with double safety protect.
The tool equipped with a double piston pump which characterized by a fast approach towards the connecting material and transfer to high pressure automatically by slow crimping.
If a deviation from the set operation pressure or low battery charges is identified, an acoustic signal sounds and a red display flashes.
One key control-press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully means piston return to the original position.
A Temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduced to the normal.