Hydraulic Tools To Make Your Job Easier!
Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs
You are here: Home » Products » Wire Installation Tools » Battery Cable Tools » Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs
Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs
Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs

loading

Battery Wire Crimping Tools EZ-400U with Working Force 120KN,for Pressing Copper And Aluminum Lugs

Share to:
sharethis sharing button
A Temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduced to the normal.
  • EZ-400U

  • iGeelee

Availability:
Quantity:

Battery Powered Wire Crimping Tool with Micro Computer Control System,for pressing Copper and Aluminum Terminals EZ-400U

    

crimping Force     120KN     
Stroke     20mm     
Crimps per charge     150 times  (Cu 150mm2 )     
crimping cycle     4-12s (depends on the size of cable)     
Battery voltage     18V     
Battery capacity     3.0 Ah
     
Charging time     2hours     
Package     Plastic case     
Accessories     
crimping Dies.     16, 25, 35, 50, 70, 95, 120, 150, 185, 240, 300, 400mm2     
Battery     2pcs     
Charger     1pcs     
Sealing ring of cylinder     1set     
Sealing ring safety valve     1set     

 

Battery Powered Wire Crimping Tools with Micro Computer Control System

 
 Micro computer control system-automatically detect the pressure when it is crimping, with double safety protect.

 The tool equipped with a double piston pump which characterized by a fast approach towards the connecting material and transfer to high pressure automatically by slow crimping.

 If a deviation from the set operation pressure or low battery charges is identified, an acoustic signal sounds and a red display flashes.

 One key control-press the trigger to start working, half loosing the trigger means stop forcing pressure, loosing fully means piston return to the original position.

 A Temperature sensor makes the tool stop working automatically when the temperature over 60℃ under long time working, the fault signal sounds, it means the tool can’t continue work until the temperature reduced to the normal.


Previous: 
Next: 

Related Products